ENJOYING THIS POST? Share it with your colleagues Share on linkedin LinkedIn Share on facebook Facebook Share on twitter Twitter GRANT G1 PARTNERSHIP Orlando RAC are pleased to announce that we have now attained Grant G1 Partnership for their Air Source Heat Pumps for the Domestic Market. All our Engineers and Installers have completed...
ENJOYING THIS POST? Share it with your colleagues Share on linkedin LinkedIn Share on facebook Facebook Share on twitter Twitter MICROCHANNEL CONDENSER COIL REPLACEMENT During a routine Preventative Planned Maintenance visit to our customers site, we found a microchannel condenser coil with a pin-hole leak. We recovered the remaining 50 KG of the 60...
ENJOYING THIS POST? Share it with your colleagues Share on linkedin LinkedIn Share on facebook Facebook Share on twitter Twitter HOME MADE TURBOCOR TESTING TOOL If you have been endowered with big hands with banana fingers, getting to the Turbocor Compressor Bearing and Sensor Terminals can be ridiculously hard. A new Home Made Turbocor...
ENJOYING THIS POST? Share it with your colleagues Share on linkedin LinkedIn Share on facebook Facebook Share on twitter Twitter CARRIER SCREW PACK DAMAGE We took on a refrigerant leaking O-Ring replacement job on a Carrier Global III Screw Compressor body that failed it's F-Gas Check checks. During the strip-down we found the reason...
ENJOYING THIS POST? Share it with your colleagues Share on linkedin LinkedIn Share on facebook Facebook Share on twitter Twitter REPLACEMENT CHILLER WORKS We recently completed chiller replacement works for one of our long term customers. Initially we carried out validation checks on the existing chiller flow rate and power supply to make sure that...
ENJOYING THIS POST? Share it with your colleagues Share on linkedin LinkedIn Share on facebook Facebook Share on twitter Twitter BITZER SCREW LOADING PISTON SEAL CHANGE Our previous blog BETTER THAN MANUFACTURER CONTROLS UPGRADE gave us telemetry and alarming that indicated System No2 Bitzer Screw Compressor on the Climaveneta Chiller was not loading past 50%. Initially, we...
ENJOYING THIS POST? Share it with your colleagues Share on linkedin LinkedIn Share on facebook Facebook Share on twitter Twitter TURBOCOR COMPRESSOR IGV REPLACEMENT During routine PPM Tasks on one of our customers sites, run testing found the compressor under-performing and surging unexpectedly. Our investigations showed the IGV (Inlet Guide Vane) stuck closed. We found...
ENJOYING THIS POST? Share it with your colleagues Share on linkedin LinkedIn Share on facebook Facebook Share on twitter Twitter CARRIER GLOBAL CHILLER TQ VALVE FAULT.Our customer was quoted tens of thousands of pounds for a complete controls retrofit as the original Danfoss TQ Actuator used on the Liquid Subcooling HX is unsupported...
ENJOYING THIS POST? Share it with your colleagues Share on linkedin LinkedIn Share on facebook Facebook Share on twitter Twitter YORK IGBT GATE DRIVER FAULT REPAIRSÂ We now have the capability to diagnose and repair York IGBT's that are suffering from York IGBT Gate Driver Faults. We have also successfully repaired the accompanying York...
ENJOYING THIS POST? Share it with your colleagues Share on linkedin LinkedIn Share on facebook Facebook Share on twitter Twitter COPELAND RECIPROCATING COMPRESSOR TOP END OVERHAUL AND INSPECTION We haven’t worked on a recip. compressor for a while. We carried out a Copeland D4 Reciprocating Compressor Top End Overhaul, Oil Change and a Health...